Trane CSAA - Flashing Installation Location

Installation - Mechanical
44 CLCH-SVX07K-EN
Figure 51. Flashing installation
(9) Guard:
Perpendicular-to-
airflow flashing
(8) Tape:
0.12T x 1.00W
gray Butyl
(12) Guard:
Direction-of-
airflow flashing
(10) Guard:
Energy recovery
end cover
(11) Guard:
Energy recovery
end cover
(12) Guard:
Direction-of-
airflow flashing
(8) Tape:
0.12T x 1.00W
gray Butyl
(9) Guard:
Perpendicular-to-
airflow flashing
Figure 52. Flashing installation location
Detail A
Base rail
.060 gap between
bottom of panel and
top of flashing
Lower panel
Upper panel
(4) Screw:
10-16 x 0.750
self-driller
(9) Guard: Perpendicular-
to-airflow flashing
or
(12) Guard: Direction-
of-airflow flashing
(8) Tape:
0.12T x 1.00W
gray Butyl
Figure 53. Flashing end cover installation applied to
energy wheels and CDQ sections
Detail B
(8) Tape:
0.12T x 1.00W
gray Butyl
(10) Guard:
Energy recovery
end cover
(11) Guard:
Energy recovery
end cover
(8) Tape:
0.12T x 1.00W
gray Butyl
(12) Guard:
Direction-of-
airflow flashing
(4) Screw:
10-16 x 0.750
self-driller
(12) Guard:
Direction-of-
airflow flashing
Apply caulk
(14) Adhesive/sealant:
Flex polyurethane
Assembled view