Operating
The wiper die carrier usually remains the same for all tools. Only the actual wiper die
is to be changed for different tools. Depending the size of the wiper die the carrier
must be installed on the appropriate position behind the bend die.
Drive the machine into starting position (clamping backward, bending backward)
and take a possibly inserted tube out of the machine.
Unscrew the setscrew (Pos.1) and take the wiper die out of the carrier.
Mount the wiper die for the corresponding tool.
The wiper die is adjustable via the setscrews on Pos.1 and Pos.2.
To Next Page