8-1 State
The page lets you enable or disable MSTP; you can also select what protocol version you want.
The default is Spanning Tree enabled.
Web Interface
To configure the Spanning Tree Protocol version in the web interface:
1. Click Spanning Tree and state.
2. Select “on” to enable Spanning Tree Protocol.
3. Select the Spanning Tree Protocol version.
4. Click the Apply button to save the setting.
5. To cancel the setting, click the Reset button to revert to previously saved values.
Figure 8-1: The MSTP State page
Parameter descriptions:
Multiple Spanning Tree Protocol: You can select on to enable MSTP or off to disable MSTP.
Force Version: The STP protocol version setting. Valid values are STP, RSTP and MSTP.
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...