Figure 10-2.1: MLD Snooping Basic Configuration
Parameter descriptions:
Global Configuration
Snooping Enabled : Enable the Global MLD Snooping.
Unregistered IPMCv6 Flooding enabled : Enable unregistered IPMCv6 traffic flooding.
Flooding control takes effect only when MLD Snooping is enabled. When MLD Snooping is disabled,
then unregistered IPMCv6 traffic flooding is always active in spite of this setting.
MLD SSM Range : SSM (Source-Specific Multicast) Range allows the SSM-aware hosts and routers run
the SSM service model for the groups in the address (using IPv6 Address) range.
Proxy Enabled : Enable MLD Proxy. This feature can be used to avoid forwarding unnecessary join and
leave messages to the router side.
Port Related Configuration
Router Port : Specify which ports act as router ports. A router port is a port on the Ethernet switch that
leads towards the Layer 3 multicast device or MLD querier. If an aggregation member port is selected
as a router port, the whole aggregation will act as a router port.
Fast Leave : Check the box to enable Fast Leave on the port.
Throttling : Enable to limit the number of multicast groups to which a switch port can belong.
Profile : You can select profile when you edit in Multicast Filtering Profile.
Buttons
Apply : Click to save changes.
Reset : Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...