Transition Networks SM8TAT2SA - Page 168

12-5.2 SNMPv3
Security > SNMP > SNMPv3 > Communities
The function is used to configure SNMPv3 communities. The Community is unique. To create a new
community account, please check <Add New Entry> button, and enter the account information then
check the Apply button. You can create up to six Groups.
Parameters:
Community: Enter the IP address for this new entry. Indicates the community access string to permit
access to SNMPv3 agent. The allowed string length is 1 to 32, and the allowed content is ASCII
characters from 33 to 126. The community string will be treated as security name and map a SNMPv1
or SNMPv2c community string.
Source IP: Enter the IP address for this new entry. Indicates the SNMP access source address. A
particular range of source addresses can be used to restrict source subnet when combined with source
mask.
Source Mask: Enter the
Source Mask for this new entry. Indicates the SNMP access source address
mask.
Add New Entry: Click to add a row to the table and configure the new instance.
Apply: Click to save changes when done configuring.
Reset: Click to undo any changes made locally and revert to previously saved values.