Security > SNMP > Trap Event Severity
This page displays the Trap Event Severity Configuration table:
Parameters:
Group Name: Select the name of the existing Group. This is the name identifying the severity group.
Severity Level: At the dropdown select Emerg, Alert, Crit, Error, Warning, Notice, Info, or Debug.
Every group has an severity level. These 7 levels are supported:
Emergency: System is unusable.
Alert: Action must be taken immediately.
Critical: Critical conditions.
Error: Error conditions.
Warning: Warning conditions.
Notice: Normal but significant conditions.
Information: Information messages.
Debug: Debug-level messages.
Syslog: Check the box to enable System logging of the trap event.
Trap: Check the box to enable the trap event setting.
To Next Page
Loading...