13-3 Traceroute
This page allows you to issue ICMP, TCP, or UDP packets to diagnose network connectivity
issues.
Web Interface
To configure a Traceroute in the web interface:
1. Click Diagnostics and Traceroute.
2. Specify IP Address, IP Version, IP Protocol, traceroute Size.
3. Click Start.
Figure 13-3: The Traceroute page
Parameter descriptions:
IP Address: The destination IP Address.
IP Version: Select the IP Version (IPv4, IPv6, or Domain Name).
IP Protocol: The protocol (ICMP or UDP) packets to send.
Egress Interface: Specify an egress interface for sending traceroute packets. Only used in IPv6.
Wait Time: Set the time (in seconds) to wait for a response to a probe (default 5.0 sec). Values range
from 1 to 60. The payload size of the ICMP packet. Values range from 2 bytes to 1452 bytes.
Maximum TTL: Specify the maximum number of hops (max time-to-live value) traceroute will probe.
Values range from 1 to 255. The default is 30.
Probe Count: Sets the number of probe packets per hop. Values range from 1 to 10. The default is 3.
Button
Start: Start traceroute on the port that you selected.
To Next Page
Loading...