Tag : Tag indicating whether the specified application type is using a 'tagged' or an 'untagged' VLAN.
Untagged indicates that the device is using an untagged frame format and as such does not include a
tag header as defined by IEEE 802.1Q-2003. In this case, both the VLAN ID and the Layer 2 priority
fields are ignored and only the DSCP value has relevance.
Tagged indicates that the device is using the IEEE 802.1Q tagged frame format, and that both the
VLAN ID and the Layer 2 priority values are being used, as well as the DSCP value. The tagged format
includes an additional field, known as the tag header. The tagged frame format also includes priority
tagged frames as defined by IEEE 802.1Q-2003.
VLAN ID : VLAN identifier (VID) for the port as defined in IEEE 802.1Q-2003.
L2 Priority: L2 Priority is the Layer 2 priority to be used for the specified application type. L2 Priority
may specify one of eight priority levels (0 through 7), as defined by IEEE 802.1D-2004. A value of 0
represents use of the default priority as defined in IEEE 802.1D-2004.
DSCP: DSCP value to be used to provide Diffserv node behavior for the specified application type as
defined in IETF RFC 2474. DSCP may contain one of 64 code point values (0 through 63). A value of 0
represents use of the default DSCP value as defined in RFC 2475.
Port Policies Configuration: Every port may advertise a unique set of network policies or different
attributes for the same network policies, based on the authenticated user identity or port
configuration.
Port: The port number to which the configuration applies.
Policy Id: The set of policies that will apply to a given port. The set of policies is selected by check
marking the checkboxes that corresponds to the policies.
Buttons
Adding New Policy: Click to add a new policy. Specify the Application type, Tag, VLAN ID, L2 Priority
and DSCP for the new policy. Click "Apply".
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...