SFP_Auto_AMS - Automatically determines the speed of the SFP. Note: There is no standardized
way to do SFP auto detect, so here it is done by reading the SFP rom. Due to the missing
standardized way of doing SFP auto detect some SFPs might not be detectable. The port is set in
AMS mode. Cu port is set in Auto mode.
100-FX - SFP port in 100-FX speed. Cu port disabled.
100-FX_AMS - Port in AMS mode. SFP port in 100-FX speed. Cu port in Auto mode.
1000-X - SFP port in 1000-X speed. Cu port disabled.
1000-X_AMS - Port in AMS mode. SFP port in 1000-X speed. Cu port in Auto mode. Ports in AMS
mode with 1000-X speed have Cu port preferred. Ports in AMS mode with 100-FX speed have
fiber port preferred.
Flow Control: When Auto Speed is selected on a port, this section indicates the flow control capability
that is advertised to the link partner. When a fixed-speed setting is selected, that is what is used. The
Current Rx column indicates whether pause frames on the port are obeyed, and the Current Tx column
indicates whether pause frames on the port are transmitted. The Rx and Tx settings are determined by
the result of the last Auto-Negotiation.
Check the configured column to use flow control. This setting is related to the setting for Configured
Link Speed.
Description: Enter up to 63 characters to be descriptive name for identifies this port.
Buttons
Refresh: Click to refresh the Port link Status manually.
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...