7-4 Port Shaper
This section provides an overview of QoS Egress Port Shapers for all switch ports.
Web Interface
To configure the QoS Port Shapers in the web interface:
1. Click Quality of Service and Port Shaper.
2. Select the port to configure QoS Egress Port Shaper.
3. Click the port to enable, and configure the Rate limit condition.
4. Click Apply to save the configuration.
5. To cancel the setting, click the Reset button to revert to previously saved values.
Figure 7-4: The QoS Egress Port Shaper page
Parameter descriptions:
Port : The logical port for the settings contained in the same row. Click on the port number to
configure the shapers.
Queue Shaper
Queue : The queue number of the queue shaper on this switch port.
Enable : Controls whether the queue shaper is enabled for this queue on this switch port.
Rate(kbps) : Controls the rate for the queue shaper. The default value is 1000000.
Port Shaper
Enable : Controls whether the port shaper is enabled for this switch port.
Rate(kbps) : Controls the rate for the port shaper. The default value is 1000000.
Buttons
To Next Page
Loading...