Unipulse F372A - 6 STANDARD INTERFACES; 6-1. SI;F; 6-2. RS-232 C

74
5 SETTING OF FUNCTIONS
74
SETTING OF FUNCTIONS
Chapter
5
- Reading parameters
- Commands (Host→F372A)
Digital Zero
Digital Zero reset
Print instruction
2.Continue
The indicated value is continuously transmitted.
3.Print
The indicated value is transmitted upon printing.
＊1
O ........ Sensor ±error，±OVER
S
........ Stable
M....... Not Stable
H ....... Hold
＊1 Priority H＞O＞ (S or M)
＊2
A ....... Zero Tracking OFF
T........ Zero Tracking ON
＊3
H ........ HI limit ON
L......... LO limit ON
G ........ HI limit and LO limit OFF
N ........ HI limit and LO limit ON
F
........ Compare OFF
＊3
Priority N＞ (H or L) F＞ G
＊4
H ........ HH limit ON
L......... LL limit ON
G ........ HH limit and LL limit OFF
N ........ HH limit and LL limit ON
F
........ Compare OFF
＊4
Priority N＞ (H or L) F＞ G
＊5
N ....... Near Zero OFF
Z
........ Near Zero ON
Host
F372A
Ｗ
Ｗ
CR
Set Value No. The same format as write-in
of set values.
Set Value No.
Delimiter
CR
CR
CR
Ｃ
Ｃ
Ｃ
Ｇ
Ｈ
Ｉ
(This will issue print a command onto SIF.)
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
G S ， 1 ， 2 ， 3 ， 4 ， 5 ， ±
****
HEADER
Five digits of the indicated value
Sign
＋ or －
*
Delimiter
and decimal point
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
G S ， 1 ， 2 ， 3 ， 4 ， 5 ， ±
****
HEADER
Sign
＋ or －
*
Delimiter
Five digits of the indicated value
and decimal point
Even if the HI-LO limit output selection is changed
to other than H2/L2, characters will not change.