To Next Page

To Previous Page

INSTALLATION

Take the Horizon remote control in your hand and carefully remove

the shroud from the Horizon remote control battery compartment.

With the arrows UP and DOWN select your preferred language, press

OK to conrm your choice.

The Horizon box will set up the required congurations. After a few

minutes you should see the personalisation message. Choose whether

you wish to receive personalised recommendations for programmes

and lms (for more information on personalised recommendations

please refer to the chapter “SUGGESTED”).

Installation is now completed. Enjoy Horizon!

Switch on your TV using your TV remote control.

Press the “Source” button on your TV remote control to choose the

HDMI channel to which you have connected the HDMI cable.

The Horizon Box now downloads the latest software (if available);

this can take around 20 minutes. When the software has been

downloaded, you will be asked to select the language of your choice.

Plug the power cable into the power pack and connect the other

end to a power point. Plug the power pack into the Horizon box.

Make sure that the ON/OFF switch is set to ON.

AV/SOURCE

10% R SCANNING

INSTALLATION

20 min.

HDMI-Kanal wählen

Sélectionner le canal HDMI

Seleziona il canale HDMI

Select HDMI channel

TV ON

Horizon

Channel activation may take

up to 30 minutes.

min.

B ACK

UPC Horizon User Manual

Other manuals for UPC Horizon