INTERNET & FIXED NETWORK
73
Terminate call on hold
Terminate current call and accept call on hold
Start three-way conference (during a call)
End – during a call
From the function “Hold”
Press or
R
wait for the dialling tone and press
0
.
The existing call remains active.
Press or
R
wait for the dialling tone and press
1
.
The call on hold becomes active.
Replace receiver (both calls are terminated).
To switch back and forth between participants:
Press
or
R
, wait for the dialling tone, enter
2
.
First connection is put on hold, second remains active.
Press or
R
, wait for the dial tone and enter the desired number;
press
or
R
again wait for the dialling tone and confirm with
3
.
Press
R
or
3
and wait.
If you terminate one of the two calls (by replacing the receiver),
the phone will ring to indicate that the other call remains active.
You can accept the call by picking up the receiver while the phone
is ringing.
Three-way conference
During a call, you can add another person to the conversation or
exclude them again at any time without terminating the existing call.
Fax
You can also connect a fax machine for data transmission to the cable
modem. The fax groups 2/3 (up to 14.4 kbit/s) are supported.
Hold and accept a new incoming call
Press or
R
and wait for the dialling tone.
Select the number
2
for questions (within 20 seconds)
and wait for a connection.
Press or
R
, then
2
to switch between the connections / calls.
Hold
This enables an existing call to be placed on hold in order to query
something with another subscriber on the same line or to answer
a waiting call (that has already been signalled). The existing call is held
in the exchange.
B ACK
To Next Page
Loading...
