2AV/X
1-3-17
1-3
Silent mode
Selects whether or not to enter silent mode after
copying.
1. Select “F22” and press the enter key.
2. Select “on” or “off” and press the enter key.
Setting range: 1 (on)/2 (off)
Copy eject location setting
Selects whether to eject copies to the internal eject
tray or job separator.
1. Select “F23” and press the enter key.
2. Select the copy eject location and press the
enter key.
Setting range: 1 (internal eject tray)/
2 (job separator)
Note: This setting item will not be displayed if
the optional job separator is not installed.
Auto shutoff
Sets whether the auto shutoff function is available.
1. Select “F24” and press the enter key.
2. Select “on” or “off” and press the enter key.
Setting range: 1 (on)/2 (off)
Auto preheat time
Sets the auto preheat time.
1. Select “F25” and press the enter key.
2. Select the setting and press the enter key.
Setting range: 5 to 45 minutes (in 5-minute
increments)
1 (5 min)/2 (10 min)/3 (15 min)/4 (20 min)/
5 (25 min)/6 (30 min)/7 (35 min)/8 (40 min)/
9 45 min)
Note: Set the auto preheat time to be shorter
than the auto shutoff time.
Auto shutoff time
Sets the auto shutoff time.
1. Select “F26” and press the enter key.
2. Select the setting and press the enter key.
Setting range: 15 to 240 minutes (in 15-minute
increments)
1 (15 min)/2 (30 min)/3 (45 min)/4 (60 min)/
5 (75 min)/6 (90 min)/7 (105 min)/8 (120 min)/
9 (135 min)/10 (150 min)/11 (165 min)/
12 (180 min)/13 (195 min)/14 (210 min)/
15 (225 min)/16 (240 min)
Toner counter report
Prints the report on the toner consumption ratio.
1. Select “F27” and press the enter key.
If A4/11" × 8
1
/
2
" paper is present, the list is
automatically printed out. Otherwise, select
the paper source and press the start key.
To Next Page
Loading...
Need help?
General
