LIFTING THE IP00 DRIVE MODULE, MR10 OR MR12 WITHOUT THE OPTIONS MODULE
1 Make sure that the support is attached to the
bottom of the drive. It gives the terminals
protection when you lift the drive or put it vertically
on the floor.
A. The support / fixing bracket
2 Lift the drive with a lifting device. Put the lifting
hooks in the holes on the top of the cabinet. The
maximum lifting angle is 60 degrees.
3 After the lifting, you can remove the support if
necessary. You can also use it as a fixing bracket.
LIFTING THE IP00 DRIVE MODULE, MR10 OR MR12 WITH AN OPTIONS MODULE
1 Remove the drive from the package.
2 Use a lifting device that is sufficiently strong for the
weight of the drive.
3 Put the lifting hooks in the holes on the top of the
cabinet.
VACON · 18 RECEIVING THE DELIVERY
3
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
To Next Page
Loading...
