5. Press the OK button or the selector for the predefined factory/user settings.
The function is removed from the programme.
With a short press of the ESC button you can return to the menu 2. A long press
of the ESC button returns to the previously active drive display.
3.19.8.4 Adding a new programme function
1. Enter the programme editing view.
2. Press left and right arrow buttons or rotate the selector for the predefined
factory/user settings to move the selection between the functions you are
going to add the new function.
3. Press the up arrow button.
The function selection view appears.
GUID-56D2836F-28EB-46FD-90F7-3C93837EB080
4. Press arrow buttons or rotate the selector for the predefined factory/user
settings to move the selection over the needed function.
NOTE: You can discard the made changes and return the previous view by
pressing ESC.
5. Press the OK button or the selector for the predefined factory/user settings.
The function is added to the programme with 1 m distance to other functions.
With a short press of the ESC button you can return to the menu 2. A long press
of the ESC button returns to the previously active drive display.
3.19.8.5 Moving a programme function
1. Enter the programme editing view.
2. Press left and right arrow buttons or rotate the selector for the predefined
factory/user settings to move the selection to the function you are going to
move.
3. Operation
- 263 -
To Next Page
Loading...
