Maintenance check point 10 h 50 h 600 h 1200 h 2400 h
Check the wheel nut tightness. ● ● ●
Check the brake pedal free travel. ● ● ●
Check the parking brake. ● ● ●
Change the oil filters of the transmission and hydraulic system. ● ● ●
Check the engine breathing system. ● ● ●
Check the oil level in the front axle differential and hubs. ● ● ●
Change the oil in the hubs of the front axles with brakes. ● ● ●
Change the front power take-off oil and wash the oil filter. ● ● ●
Check the front power take-off couplings. ● ● ●
Grease the rubber surfaces of the trailer quick couplings. ● ● ●
Check the integrity of the air pressure system. ● ● ●
Check the air pressure system automatic water draining. ● ● ●
Fill the air pressure system antifreeze container. ● ● ●
Adjust the engine valves.
●
3)
Run the transmission automatic calibration.
●
4)
Change the oil in the hydraulic system. ● ●
Change the oil in the front axle differential and hubs. ● ●
Change the fuel filter and prefilter.
●
5)
●
Change the engine air filters.
●
6)
●
Change the selective catalytic reduction system supply module
main filter.
● ●
Check the front wheel toe-in. ● ●
Change the hydraulic breather. ● ●
Check the power shuttle operation. ● ●
Change the oil in the transmission system. ●
Change the transmission breather. ●
Clean the suction strainer. ●
Bleed the brake system. ●
Bleed the front axle brake system. ●
Clean the cooling system. ●
Change the cap of the coolant expansion tank. ●
Check the engine vibration damper. ●
Check the cab mounting. ●
Maintain the air conditioning. ●
1)
NOTE: In extremely dusty conditions or when using first generation Biodiesel fuel with dilution
over 7%, change the oil and filters every 250 hours. With second generation Biodiesel fuel the
service interval is normal (600 hours).
2)
NOTE: In extremely dusty conditions the cab ventilation air filter must be cleaned frequently.
3)
NOTE: The engine valves must be adjusted after 600 operating hours. After the first adjustment,
adjust the valves every 1200 hours.
4)
NOTE: The transmission automatic calibration must be run after 600 operating hours. After the
first calibration, run the calibration every 1200 hours.
5)
NOTE: When using first generation Biodiesel fuel with dilution over 7%, change the fuel filter
and prefilter every 500 hours. With second generation Biodiesel fuel the service interval is
normal (1200 hours).
6)
NOTE: In extremely dusty conditions the engine air filters must be changed more frequently.
4. Maintenance
- 310 -
To Next Page
Loading...
Need help?
General
