1. Run the tractor, and raise and lower the hydraulic lift (or e.g. the front loader)
until the oil is a little warm.
2. Raise the front linkage and lower the front loader and rear linkage.
Maximum amount of oil returns to the hydraulic oil reservoir.
3. Remove the drain plug under the housing.
GUID-FC851E63-2F23-45E2-98E6-F02CAA237B1F
1. Hydraulic oil drain plug
4. Drain the oil into a suitable container.
5. Clean and refit the plug.
Renew the copper washer.
6. Refill by pump through the hydraulic return coupling.
GUID-93D0D119-C361-4CA1-A851-847F9A21FDDB
1. Hydraulic return coupling
The oil must go through the return filter so that no impurities enter the
system.
4. Maintenance
- 355 -
To Next Page
Loading...
