• Turn the seat.
• Release the lock by pulling the locking lever upwards.
• Turn the seat to the desired position.
You can turn the seat between 190° anti-clockwise and 90° clockwise
from the normal position. The seat can be locked to set positions at 10°,
20°, 80° and 90° when turning clockwise and 10°, 20°, 180° and 190°
when turning anti-clockwise.
• Adjust the vertical shock absorption.
The adjusting knob has five positions.
• To decrease the level of damping, turn the knob backwards.
• To increase the level of damping, turn the knob forwards.
• Adjust the seat height and vertical suspension.
IMPORTANT: Lifting or lowering the seat over a minute at a time can
damage the compressor.
The seat has pneumatic height adjustment. The seat adjusts the vertical
suspension automatically according to the operator's weight.
• To lift the seat, pull the height adjustment lever upwards. Release the
lever when required height is reached.
• To lower the seat, push the height adjustment lever downwards. Release
the lever when required height is reached.
If you set the seat too high or low, the seat adjusts automatically to the
nearest permissible position to maintain the required margin for upward or
downward suspension.
• Adjust the seat lateral suspension.
Lateral suspension is not in use if the tractor is equipped with reverse drive
controls.
The lateral suspension is either on or off.
• To turn on the lateral suspension, pull the handle to the upper position.
• To turn off the lateral suspension, push the handle to the lower position.
3. Operation
- 60 -
To Next Page
Loading...
Need help?
General
