PaX-i (PCH-2500) User Manual
104
9. Cleaning and Maintenance
9.
Cleaning and Maintenance
WARNING
Always turn off the power to the equipment and disconnect
it from the power outlet before cleaning.
9.1
Cleaning
■
Thoroughly clean areas of the equipment which come into contact with the
patient, such as the handle frame, chin support and bite block.
■
Do not use spray cleaners or solvents as they could enter the equipment
and damage to the electrical components or cause a re.
■
Do not use abrasive liquids such as acetone, gas, or oil, which could
corrode the surface of the equipment.
■
Do not use cleaning products which contain silicon as they could potentially
damage the equipment’s electrical components.
The following table summarizes the standard cleaning procedures to be
performed by the operator.
Accessories Cleaning Process
Bite block
Clean the bite blocks using an alcohol-based
disinfectant and dry thoroughly with a soft dry
cloth, before each patient is X-rayed.
Temple support
Clean the temple support using an alcohol-
based disinfectant and dry thoroughly with a
soft dry cloth before each patient is X-rayed.
Chin support
Clean the chin support using an alcohol-based
disinfectant before each patient is X-rayed.
All components that
come into contact with
the patient or operator
Clean components using an alcohol-based
disinfectant before each patient is X-rayed.
Pi_u272_en_20180514.indd 104 2018-05-14 오전 11:03:30
To Next Page
Loading...
Need help?
General
