Vatech PAX-I - Acquiring CEPH Images; Setting the Exposure Parameters

PaX-i (PCH-2500) User Manual
86
7. Acquiring CEPH Images
7
Acquiring CEPH Images
 7.1
Setting the Exposure Parameters
Perform the following procedures to set the exposure parameters for the
specic patient and capture mode (for more details about CEPH imaging, refer
to section
4.3.2: CEPH Mode
).
Depending on the sensor type employed, one of two kinds of imaging S/W
comes with the equipment for the CEPH mode examination.
One-shot type sensor Scan type sensor
A. Click the
CEPH
button.
B. Select the scanning mode under
CEPH Examination. – Lateral, PA, SMV,
Waters View, Carpus.
C.
Exposure time
Exposure time can be adjusted by resolution of 0.1 s in the range of 0.7 s to 1.2
s (One-shot type only).
A
A
B
B
C
Pi_u272_en_20180514.indd 86 2018-05-14 오전 11:03:27