PaX-i (PCH-2500) User Manual
16
2. Warnings and Precautions
2.2
Electricity-related Safety Precautions
■
Check the status of the power source, PC and cables prior to operating the
equipment.
■
Ensure that the on/off switch is set to off when the equipment is not in use.
■
Always disconnect the power supply before cleaning the equipment.
■
Always keep electrical cords away from hot appliances or radiators.
■
DO NOT place the PC or peripheral equipment connected to the PC in the
immediate vicinity of the patient.
■
The equipment and PC should be connected to a common protective earth.
■
Never overload the equipment’s circuit by sharing it with too many
appliances.
■
Use the same power circuit for the PC and the equipment.
Combining this equipment with other devices
■
Do not connect this equipment to devices which are not part of the system.
■
Do not connect this equipment to a Multiple Portable Socket-Outlet (MPSO)
or extension cord.
Electromagnetic compatibility
■
The PaX-i X-Ray unit complies with IEC standard 60601-1-2.
■
Medical electrical equipment is subject to special EMC preventive
measures. It must be installed and operated as specied in the
Installation
Requirements
document.
■
If high-voltage systems, radio link systems or MRI systems are located
within 5 m of the unit, please observe the specifications stated in the
installation requirements.
■
Portable and mobile RF communications equipment may interfere with
medical electrical equipment. Therefore, the use of mobile wireless phones
in medical ofces or hospital environments must be prohibited.
Pi_u272_en_20180514.indd 16 2018-05-14 오전 11:03:09
To Next Page
Loading...
Need help?
General
