PaX-i (PCH-2500) User Manual
80
6. Acquiring PANO Images
6.4
Initiating X-Ray Exposure
The X-Ray exposure method and its sequences are the same for PANO
Standard and PANO Special modes. The example used in this manual is the
PANO Standard mode.
To emit the X-ray, perform the following procedure.
WARNING
If a problem occurs during image acquisition, press the
red emergency stop button to immediately stop all moving
parts and cut off all power to the equipment’s electrical
components. You may then safely release the patient from
the equipment.
To reset this button, turn it clockwise until it pops up.
WARNING
- Do not operate the PC during exposure. Failure to
comply with this instruction may cause the system to
malfunction.
- The operator shall observe the X-Ray safety regulations
applicable to their area at all times during the operation
of this equipment.
If an emergency occurs during image acquisition, release
the exposure switch to cease X-Ray emission.
E
M
E
R
G
E
N
C
Y
S
T
O
P
Pi_u272_en_20180514.indd 80 2018-05-14 오전 11:03:26
To Next Page
Loading...
Need help?
General
