EasyManuals Logo

Vatech PAX-I User Manual

Vatech PAX-I
137 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
PaX-i (PCH-2500) User Manual
18
2. Warnings and Precautions
2.4
Warnings
The following warning statements should be obeyed with the utmost care.
Failure to follow these warnings may cause severe damage to the equipment or
physical injuries to the patient and/or operator.
WARNING
X-Ray equipment is hazardous to patient and the operator
if proper exposure safety measures and/or operating
instructions are not observed.
It is important to read this user manual carefully and
strictly abide by all warnings and cautions stated within it.
WARNING
- PaX-i system, like other medical equipment, uses
high-frequency electrical signals that can interfere
with implantable devices such as pacemakers and
implantable cardioverter-defibrillators(ICDs). If the
patient has such an implantable device, you should
be aware of any interference in its operation and
immediately power off the Dental X-ray system.
- PaX-i system is designed to withstand the effects of
defibrillation. However, when possible, disconnect
the Dental X-ray systems during defibrillation since a
malfunction of the safety controls could otherwise result
in electrical burns for the patient.
Lasers
The system incorporates Class 1 laser products. The light localizers used
in this product are intended for correct patient positioning and must not be
used for any other purpose.
For maximum safety, advise the patient not to look directly at the laser
beam.
While adjusting the patient, ensure that the laser beam is not directed at the
patient’s eyes.
Equipment to liquids may cause an electrical shock or otherwise damage
the system.
Do not use spray cleaners on this equipment, as this could cause a re.
Pi_u272_en_20180514.indd 18 2018-05-14 오전 11:03:09

Table of Contents

Other manuals for Vatech PAX-I

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vatech PAX-I and is the answer not in the manual?

Vatech PAX-I Specifications

General IconGeneral
Focal Spot Size0.5 mm
Image ReceptorDigital sensor
CompatibilityDICOM 3.0
Image DetectorCMOS
Power Supply220-240 VAC, 50/60 Hz
Sensor TypeCMOS
X-ray GeneratorHigh Frequency
Tube Voltage60-90 kVp
Tube Current4-12 mA
Power Requirements100-240V AC, 50/60Hz
UsageDental diagnostics

Related product manuals