ROBOT HP7E / HP10E / HP12E / HP15E / HP20E 8. Maintenance
8-1© VEMAG 2010
8. Maintenance
8.1 General information
Apart from daily cleaning, the ller needs very little maintenance. For
your peace of mind, we recommend that you take out a service contract
whereby VEMAG Customer Service carries out all the maintenance work
due.
The information below describes the maintenance work to be perfor-
med by the owner of the machine. The types and quantities of lubricants
required are listed in the appendix. Notes on spare parts required can be
found in the spare parts catalogue.
Section 10 and spare parts catalogue
Danger!
To prevent injury, switch off the machine before any maintenance work.
Then switch off the main switch to disconnect the machine from the
mains. The machine has to be switched on for the feed unit drive to be
lubricated.
To maintain components inside the drive system the front door must be
swung open or the appropriate service hatch of the machine housing
removed.
Front door
• Undo top assembly bolt (1) of the front door using a spanner (2).
1 Assembly bolt
2 Spanner
Fig. 8-1
Opening the front door
2
1
To Next Page
Loading...
