VEMAG ROBOT HP7E - Fitting the Double Screws

ROBOT HP7E / HP10E / HP12E / HP15E / HP20E 4. Setting up
4-3© VEMAG 2010
4.3 Fitting the double screws
• Position the double screws (1) so that the screw marked left (”links”) is
on the left-hand side and the front faces are ush.
• Bring the slots of coupling claws (2) into the correct position in relation
to the coupling pins in the feed cylinder by turning the double screws
in opposite directions.
1 Double screws
2 Slots
Fig. 4-4
Lining up the double
screws
1
2
• Push double screws (1) into double screw housing (2) up to the stop.
The double screws are properly engaged if the end faces of the dou-
ble screws and housing are ush.
1 Double screws
2 Double screw housing
Fig. 4-5
Installation of double
screws
1
2