VEMAG ROBOT HP7E - Mode Groups, Modes, and Views; Start;Stop Methods

ROBOT HP7E / HP10E / HP12E / HP15E / HP20E6. Graphical control
6-24 © VEMAG 2010
6.6.1 Mode groups, modes and views
Use the Operating mode function key to select the mode group,
mode and view. You can set the mode groups and modes in the Service
area.
There are ve different mode groups:
All/Fill/Link/Portion/Miscellaneous
The mode and view depend on the selected mode group.
6.6.2 Start/stop methods
6.6.2.1 Knee I
The feed element runs only as long as the knee lever is being actuated.
6.6.2.2 Knee II
The feed element runs when the knee lever is actuated briey.
The feed element stops when the knee lever is actuated again.
6.6.2.3 Remote end
The ller is actuated by an attachment via the remote control socket.
The started portion is completed after the attachment stops.
6.6.2.4 Remote stop
The ller is actuated by an attachment via the remote control socket.
The portion is interrupted after the attachment stops.