VEMAG ROBOT HP7E - 6.6.4.44 Maximum filling pressure (pressure monitoring on grinding system); 6.6.4.45 Maximum temperature (temperature monitoring for the grinding system)

ROBOT HP7E / HP10E / HP12E / HP15E / HP20E 6. Graphical control
6-49© VEMAG 2010
6.6.4.44 Maximum lling pressure (pressure monitoring on grinding system)
Display: Max. lling pressure
Unit: Bar [bar]
Resolution: 0.1 bar
Setting range: Off / 10 – 50 bar (depending on the machine)
Application: Separation grinder 982, separation attachment 801
• Enter max. lling pressure which, when reached, will cause the
machine to stop.
• Press Enter.
This function monitors pressure in separation grinder 982/ separation
attachment 801. Current pressure is displayed in bar. When the maximum
pressure entered is reached, the machine is stopped. Pressure can be
reduced by reducing speed.
The pressure is monitored even if these settings are deactivated. In this
case, the monitoring refers to the maximum value set in the machine
conguration settings.
Warning!
The machine stopping can be an indication that blades and hole plates
are blocked with sinew. In this case, clean the blade set.
6.6.4.45 Maximum temperature (temperature monitoring for the grinding system)
Display: Temperature
Unit: Degrees [°C] / Kilogram [kg]
Resolution: 0.1 °C / 1 kg
Setting range: Off / -19.9 °C – +31.0 °C / 1,0 kg - 99 kg
Application: Separation grinder 982, separation attachment 801
• Enter the max. temperature, at which to sound the alarm.
• Enter the min. temperature to dene a temperature range you wish to
monitor.
• Enter the lling volume still to be reached after the alarm is sounded
before the machine stops.
• Press Enter.
This function monitors temperature in separation grinder 982/ separation
attachment 801. Current temperature is displayed in degrees Celsius.
If the temperature is outside the dened range, a message is issued
and the relevant indicator comes on.