VEMAG ROBOT HP7E - Page 6

ROBOT HP7E / HP10E / HP12E / HP15E / HP20EIndex
iv © VEMAG 2010
8. Maintenance 8-1
8.1 General information 8-1
8.2 Grease gun 8-5
8.3 First-time maintenance work 8-6
8.4 Maintenance schedule 8-7
8.5 Daily maintenance 8-8
8.5.1 Feed unit seals (lubrication) 8-8
8.6 Weekly maintenance 8-10
8.6.1 Feed unit drive (lubrication) 8-10
8.6.2 Intake (air lter) 8-11
8.6.3 Vacuum pump (air lter) 8-12
8.6.4 Vacuum pump 16 m³ and 40 m³ (optional) 8-12
8.7 Monthly maintenance 8-13
8.7.1 Double screw drive (oil level and seals) 8-13
8.7.2 Vacuum pump 16 m³ and 40 m³ (optional) 8-13
8.8 Six-monthly maintenance 8-14
8.8.1 Feed unit seals 8-14
8.8.2 Hydraulic unit (oil level) 8-14
8.8.3 Vacuum pump 16 m³ and 40 m³ (optional) 8-14
8.9 Annual maintenance 8-15
8.9.1 Feed unit drive and feed unit seals 8-15
8.9.2 Hydraulic unit (oil change) 8-15
8.9.3 Vacuum pump 16 m³ and 40 m³ (optional) 8-16
8.10 Biennial maintenance 8-20
8.10.1 Double screw drive (oil change) 8-20
8.11 Three-yearly maintenance 8-21
8.11.1 Feed drive (oil change) 8-21
9. Troubleshooting 9-1
9.1 General information 9-1
9.2 Troubleshooting table 9-1
10. Appendix 10-1
10.1 General information 10-1
10.2 Technical data ROBOT HP7E / HP10E / HP12E / HP15E /
HP20E 10-2
10.3 Dimensional drawings ROBOT HP7E / HP10E / HP12E /
HP15E / HP20E 10-3
10.3.1 Hopper 250 l 10-3
10.3.2 Hopper 350 l 10-3
10.4 Electrical control panel (service hatch, right-hand side) 10-5
10.5 Drive controller ROBOT HP7E (front door) 10-7
10.6 Drive controller ROBOT HP10E / HP12E (front door) 10-9
10.8 Hydraulic plan 10-12
10.9 Lubricants 10-13
10.9.1 Double screw drive 10-13
10.9.2 Feed drive 10-13
10.9.3 Hydraulic unit lifting and tipping device (optional) 10-13
10.9.4 Vacuum pump 10-13
10.9.5 Feed unit seals and feed unit drive 10-13
10.9.6 Individual parts 10-13
10.10 Accessories 10-14
10.10.1 Double screw selection 10-14
10.10.2 Filling horn selection 10-14
10.10.3 Linking horns 10-15
10.10.4 Miscellaneous accessories 10-15
10.10.5 Tools 10-15