Manual VIPA CPU 21x Chapter 4 Deployment of the CPU 21x-2BT10 with TCP/IP
HB103E - Rev. 05/45 4-19
Fast introduction
At the first start-up of a CPU 21x-2BT10 the CP of the CPU 21xNET does
not have any IP address. The assignment takes place directly via the
hardware configuration of the Siemens SIMATIC Manager. For the project
engineering of a CPU 21xNET please follow this approach:
• Assembly and commissioning
• Hardware configuration (Inclusion of CP in CPU)
• CP project engineering via NetPro (connection to Ethernet)
• PLC programming via user application (connection to PLC)
• Transfer of the complete project to CPU
To be compatible to the Siemens SIMATIC Manager, the CPU 21x from VIPA has to be
configured as
CPU 315-2DP (6ES7 315-2AF03-0AB0) V1.2
The CP of the CPU 21xNET is always configured virtually as 4
th
module at the standard
bus as CP343-1 (343-1EX11) from Siemens.
To be able to address the modules they have to be projected in the hardware
configurator from Siemens in form of a virtual Profibus system. The full functionality
of the System 200V modules is provided by inclusion of a GSD-file from VIPA.
• Install your System 200V with the CPU 21xNET.
• Wire the system by connecting cables for voltage supply, signals and
Ethernet. A detailed description is to be found in the chapter "Assembly
and installation guidelines" of the Manual HB97.
• Switch on the voltage supply. → After a short boot time, the CP is in
idle.
At the first commissioning res. after an overall reset of the CPU, the CP
has no IP address. For control purposes you may now reach the CP via
the MAC address. The MAC address is to be found at a small label on
the module.
Overview
Note!
Assembly and
commissioning
To Next Page
Loading...
Need help?
General
