CO Line - Identification 2-77
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
XXX-XXX = CO Line Range
4. Press the CO LINE IDENTIFICATION flexible button (Button #11). The following displays:
5. Enter the name by using keys on the dial pad as follows. Valid alphanumeric characters
are: [A-Z], [0-9], [
], [#], [-], [spaces] and other ASCII characters as listed in Figure 2-3.
Any combination up to 12 characters may be entered (this represents 24 digits entered).
Figure 2-3: Dial Pad Keys
6. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
If HOLD is pressed without entering a CO line range, all CO lines are selected.
XXX - XXX PAGE A
ENTER BUTTON NUMBER
LINE IDENTIFICATION
LINE 001
Other Codes
1 = 1# 8 = 8# “ = 01 * = *#
2 = 2# 9 = 9# , = 02 ( = #1
3 = 3# 0 = 0# ? = 03 ) = #2
4 = 4# Space = 11 / = 04 + = #3
5 = 5# : = 12 ! = *1 = = #4
6 = 6# - = 13 $ = *2 # = ##
7 = 7# ‘ = 14 & = *4 . = 24
If an error is made while entering digits, press HOLD to save the erroneous
entry. Key in digits over the old name; if excess characters remain, use the digits
[11] to transpose spaces over the undesired characters.
To Next Page
Loading...
