Inter-Digit Time-Out 2-189
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Intercom Transfer
To use Intercom Transfer without DSS Buttons:
1. Receive or make an intercom call.
2. Press the TRANS button. Intercom dial tone sounds.
3. Dial the station.
4. When the second station answers, you are in a supervised transfer mode (first station is
staged for transfer).
5. Hang up (stations 1 and 2 are connected).
To use Intercom Transfer with DSS Buttons:
1. Receive or make an intercom call using a DSS button.
2. Press the TRANS button. Intercom dial tone sounds.
3. Press the DSS button where to transfer the call.
4. Hang up (stations 1 and 2 are connected).
Inter-Digit Time-Out
The Inter-Digit Time-Out feature allows programming of the inter-digit time-out on a
system-wide basis. This feature applies to intercom calls. DISA inter-digit time-out remains
unaffected by this timer. The Inter-Digit Time-out setting is variable from 1-99 seconds.
Programming Steps
1. Press the INTER-DIGIT TIMEOUT flexible button (FLASH 01, Button #20). The following
message displays:
2. Enter a valid number that corresponds to 01-99 seconds in 1-second increments.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Inter-Digit Time-out is set for 5 seconds.
INTERDIGIT T / O 01-99
05
To Next Page
