CO Line - Access 2-67
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
EXAMPLE 1 -- If [01003] is dialed and the HOLD button is pressed, the CO line number of
the first entry on the display changes to [003]. Since [003] was shown as the third entry on
the display, that entry is blank (###).
EXAMPLE 2 -- If Button #3 (CO Ports 9-12) is pressed, the following display appears:
EXAMPLE 3 -- If [03012] is dialed, the CO line number of the third entry on the display
changes to [012]. Since [012] was shown as the fourth entry, that entry is blank (###).
CO Line - Access
Description
Through programming, telephones are allowed or denied access to particular outside lines or
line groups. Refer to “Line Group Access - Station” on page 2-73, “Flexible Button Function
Assignment” on page 2-163, and “CO Line Group Programming” on page 2-74.
Operation
To access an outside line:
1. Press idle CO line button, POOL button,
-or-
Dial CO line group access code or LCR code: 9, 801-823 or 88+LLL
(LLL = CO Line number).
2. Dial desired number for outside call and lift handset to converse (or use speakerphone).
SINGLE LINE TELEPHONE
To access an outside line:
1. Lift the handset, and dial access code: 9, 801-823, or 88+LLL (LLL = CO line number).
2. Then dial telephone number.
Conditions
» Access to trunk group must be programmed by installer/administrator.
» The CO line must be idle.
CO 003 002 ### 004 005
CO 009 010 011 012
CO 009 010 012 ###
When all the CO Line numbers desired have been programmed, a system reset
is required to update the data. This is done so that the programming of CO
Lines can be done while the system is in use.
To Next Page
Loading...
