Voice Mail Outpulsing Table 2-351
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
One-Touch Recording Warning Tone
Description
The One-Touch Recording Warning Tone feature lets the installer enable/disable the
One-Touch Recording Warning Tone on a system-wide basis.
Programming Steps
1. Press the ONE-TOUCH RCD WARNING TONE flexible button (FLASH 06, Button #10). The
following message displays:
2. Enter a 0 or 1 on the dial pad to enable/disable the use of this feature.
[0] = Disabled
[1] = Enabled
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … Recording Warning Tone is enabled.
Voice Mail Outpulsing Table
Voice Mail In-Band Signaling
Description
Entries in one of the eight Voice Mail Outpulsing Tables determine the In-Band signaling
required for:
Retrieving messages (allows stations to pick up mail).
Leaving messages (allows stations to leave messages in voice mail).
Suggested Uses:
Build a table (0 for example) for any additional digits other than the station extension
number (e.g., Voice Mail Box number) needed for a caller to leave a message in a station’s
mailbox (Leave).
Build another table (1 for example) for any additional digits needed for a mailbox holder
to retrieve a message (Retrieve). By Default:
Use of this feature when the One-Touch Recording Warn Tone is disabled may be
interpreted as a violation of federal, state, or local laws, and an invasion of privacy.
Check applicable laws in your area before recording calls using this feature.
RECORDING WARN TONE 0-1
ENABLED
Table 0 Prefix = P7 (Pause+7) Suffix = None
Table 1 Prefix = P7 (Pause+7) Suffix =
Table 7 Prefix = P7 (Pause+7) Suffix = 2 (Used for One-Touch Record)
To Next Page
Loading...
