Attendant Override 3-13
Attendant Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Attendant Override
Description
Attendant stations may override a busy station or ring a station in DND. While busy, pressing
the override key provides override tone and a five second delay before voice cut-through to
the called party occurs, automatically placing any outside line call on Hold. The Attendant
Override function must be programmed onto a flexible button and can be enabled or
disabled.
Programming Steps
1. Press the ATTN OVERRIDE flexible button (FLASH 05, Button #1).
2. Enter a valid number (0 or 1) that corresponds with the following entries:
[0] = Disabled
[1] = Enabled
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … Attendant Override is disabled.
Operation
To call a station busy on a CO call:
Press the preprogrammed ATTN OVERRIDE button [601]. A long tone is presented to the
called party.
After five seconds, the station’s CO line is automatically placed on hold and the Attendant
is cut-through.
To call a station in Do Not Disturb mode:
Press the preprogrammed ATTN OVERRIDE button. The station is signaled with a
Camp On tone.
ATTENDANT OVERRIDE 1-0
DISABLED
Attendant Override functions ONLY when the Attendant station is assigned a
flexible button designated as Attendant Override.
To Next Page
