2-128 Direct Inward Dialing
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Print DID-TIE Parameters
Description
The Print DID-TIE command dumps the entire database as a permanent record which can
serve as a hard copy of the database. The system baud rate must match that of the printer or
receiving device.
When printing the DID-TIE Timers, the following data is printed:
DID Parameters and Timers
TIE Line Parameters and Timers
Programming Steps
1. Press the DID-TIE PARAMETERS flexible button (FLASH 85, Button #14). The following
message displays:
2. To print the DID-TIE Parameters, press the HOLD button. The following message displays:
When the system has finished sending the requested information to the printer,
confirmation tone sounds.
DID SIGNALING - WINK
DID DIGITS - 3
TIE SIGNALING - WINK
DID INC SIGNALING - DTMF
TIE INC SIGNALING - DTMF
T1 INC SIGNALING - DTMF
Figure 2-6: DID-TIE Parameters Printout
PRINT DID/TIE TMRS
PRESS HOLD
PRINTING DID/TIE TMRS
To Next Page
Loading...
