2-242 Paging
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Paging
Description
Stations can individually be allowed or denied the ability to make pages. This applies to all
internal and external zone paging. A station denied access to paging may still answer a
Meet-Me Page announcement. (Station COS 6 does not deny a station the ability to make a
page.)
External paging requires a three-digit dialing code and an externally provided amplifier and
paging system. The page zone has a relay contact associated to it.
There are 20 internal paging zones available. A station can be in any or all zones or in no zone
at all. Stations not assigned to a page group can still make page announcements, if allowed in
station programming. Stations can be assigned to a page group in order to receive pages but
not allowed to make page announcements.
Operation
If you were given the ability to make page announcements:
1. Lift handset or press ON/OFF button, then press the preprogrammed PAGE button or dial
the paging code.
[700] = All Call - Internal and External
[701- 720] = Internal Zone 1-20
[721] = Internal All Calls
[761] = External Zone
-or-
Use the Soft Key’s ALLPG IN or ALLPG OUT options (versus codes 721 or 761) when in an
idle condition.
2. Stations receiving a Page Announcement can press the Volume Bar to change the paging
volume. The following message displays:
SINGLE LINE TELEPHONE
If you were given the ability to make page announcements:
1. Lift the handset or press the Speaker button.
2. Dial the paging code.
[700] = All Call - Internal and External
[701- 720] = Internal Zone 1-20
[721] = Internal All Calls
[761] = External Zone
3. Speak in normal tone of voice to deliver message.
4. Replace handset to terminate the page announcement.
SPEAKER PAGE [#########]
MMM DD YY HH:MM am
To Next Page
Loading...
