Vodavi Starplus STSe - Voice Mail System Message Wait Indications

2-354 Voice Mail System Message Wait Indications
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Voice Mail System Message Wait Indications
Description
The analog voice mail system will automatically produce message waiting indications. If
there are problems with message waiting indications, a system administrator or technical
support personnel can connect an SLT to the voice mail system and use the following
procedures to simulate message waiting information.
Operation
Enabling a Voice Mail Message Wait
To receive a message waiting indication that one or more voice message(s) is waiting, the
Voice Mail system must be programmed to provide the indication to a specific user. The
system administrator does this programming using the following procedure.
1. Dial the Voice Mail Message Set code [420] on the dial pad.
2. Dial the 2- to 4-digit mailbox number of the station user who will receive voice messages.
Turning Off the Message Waiting Lamp
The voice mail system must be programmed to go off-hook when a station user retrieves the
voice messages from the voice mail system. The system administrator does this
programming using the following procedure.
1. Dial the Voice Mail Message Cancel code [421] on the dial pad.
2. Dial the 2- to 4-digit mailbox number of the station user who will receive voice messages.
Enabling a Voice Mail Message Wait with Count
To receive a message waiting indication that voice message(s) are waiting and the number of
messages that are in the mailbox, the Voice Mail system must be programmed to provide
these indications to a specific user. The system administrator does this programming using
the following procedure.
1. Dial the Voice Mail Message Set w/Count code [422] on the dial pad.
2. Dial the 2- to 4-digit mailbox number of the station user who will receive voice messages.
3. Dial a 3-digit number (000-127) that represents the amount of voice mail messages in the
mailbox.
Conditions
Only VM extensions are allowed to turn ON/OFF VM message wait indications.