3-14 Attendant Setting Time and Date
Attendant Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Attendant Setting Time and Date
Description
The System Time/Date must be set in admin programming or by the first programmed
Attendant using feature code 692.
Programming Steps
To set the time and date that appears on display telephones:
1. Press FLASH and dial [11]. The following message displays:
MMM = Month
DD = Day
YY = Year
HH= Hour
MM = Minute
2. Choose display format by pressing flexible button #1 to toggle between the standard
12-hour format or the 24-hour format (LED off = 12-hr display, LED on = 24-hr display).
3. Dial the time and date in the order shown below (2 digits for each entry, for a total of
10 digits):
Year
Month
Day
Hour
Minute
4. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Time is set for 12-hour display format.
Operation
1. Dial [692] on the dial pad. A confirmation tone sounds.
2. Enter date and time as follows: YYMMDDHHMM
When the correct number of digits are entered, a confirmation tone sounds.
3. Press the ON/OFF button to OFF to update the display.
DATE AND TIME
MMM DD YY HH:MM am
To program a pm time after selecting the 12-hour format, use 24-hour
numbering, e.g., To program a time of 5:00 pm, enter 17:00.
YY = Year (00-99) HH = Hour (00-23)
MM = Month (01-12) MM = Minute (00-59)
DD = Day (01-31)
To Next Page
Loading...
