2-310 T-1 Trunking
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
T-1 Collect Timer
Description
The T-1 Collect Timer is only used when the T-1 Incoming Signaling is set for dial pulse. This is
a time-out timer that looks at the incoming digits one digit at a time.
If a second digit isn’t detected within the 150 ms, the telephone system attempts to process
that digit. If a second digit is detected, the system waits 150 ms to see if a third digit is
received. Otherwise, the telephone system attempts to process the two digits already
received. This process continues until no additional digits are received and the time-out
timer expires.
The T-1 Collect Timer setting is variable from 100 ms to 2.0 seconds.
Programming Steps
1. Press the T-1 COLLECT TIMER flexible button (FLASH 40, Page C, Button #10). The
following message is shown on the display phone:
2. Enter a valid number on the dial pad which corresponds to 010–200 (100 ms to
2.0 seconds).
3. Press the HOLD button to save the entry. A confirmation tone sounds and the display
updates.
DEFAULT … T-1 Collect Timer is set for 150 ms.
T-1 Incoming Signaling
Description
The T-1 Incoming Signaling option allows the installer to determine the type of incoming
signaling to be used by all T-1 trunks in the system.
Programming Steps
There are two types of T-1 Signaling available for T-1 Trunks. To change the type of signaling:
1. Press the T-1 INCOMING SIGNALING flexible button (FLASH 41, Button #6) for
programming the type of T-1 signaling desired. The following message is shown on the
display phone:
2. Enter a 0 or 1 on the dial pad.
[0] = Dial Pulse
[1] = DTMF
3. Press the HOLD button to save the entry. Confirmation tone sounds and display updates.
DEFAULT … T-1 Signaling type is set for DTMF.
T1 COLLECT TIMER 010-200
015
T1 INC SIGNAL 0-1
DTMF
To Next Page
Loading...
