Hot Keypad 2-179
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Hot Keypad
Description
The Hot Keypad feature enables a station user to activate the telephone by dialing digits or
pressing telephone buttons without going off hook.
Hot Line / Ring Down
Description
Stations may be programmed to immediately call or ring down a particular station or outside
number upon going off hook. This is done by programming the stations Off-Hook preference
to activate a DSS or Speed dial feature key (refer to “Ring Down / Hot Line / Off-Hook
Preference” on page 2-263). This feature can be overridden if the station user selects a CO line
first when going off-hook.
Hunt Groups
Description
The system can be programmed for up to 12 Hunt Groups, 4 of which are only for RAN
applications in UCD. Each Hunt Group can contain up to 24 stations each. Each Hunt Group
can be independently arranged to use a pilot hunting or station hunting technique. If a
station is in DND or is forwarded in any manner, it is considered busy.
Programming Steps
1. Press FLASH and dial [30]. The following message displays:
The top left button in the flexible button field is lit for programming Hunt Group 1
(XXXX = flexible hunt group number).
2. To change Hunt Groups or enter a different Hunt Group, press the appropriate flexible
button 1-8. Hunt Groups 458-461 are only used for RAN applications in UCD (refer to
Chapter 4, Uniform Call Distribution).
3. Enter a valid 3- or 4-digit flexible station number, or flexible station numbers up to eight
stations per group, followed by a “1” to add or a “0” to delete. Hunt groups are joined or
chained together by entering another Hunt Group Pilot Number as the last entry of the
group.
4. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
HXXXX ####, ####, ####
####, ####, ####, ####, ####,
To Next Page
Loading...
