2-308 T-1 Trunking
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
T-1 Ringback Option
Description
The T-1 Ringback option supports T-1 channels which require ringback tone to be
transmitted to the caller while a call is ringing. Some carriers require the system to generate
the ringback tone, this feature allows the system to provide this option. Ringback tone is not
used with the DISA, TIE Line, or DID signal options.
Programming Steps
1. Press the RINGBACK OPTION flexible button (FLASH 40, Page B, Button #2). The
following message displays:
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
[0] = Disabled
[1] = Enabled
3. Press the HOLD button. A confirmation tone sounds and the display updates.
DEFAULT … T-1 Ringback option is enabled.
T-1 Dial Tone Option
Description
An option has been added to support T-1 channels which do not supply dial tone. Some
carriers require the system to generate dial tone to its users, while other carriers do not.
Programming Steps
1. Press the T-1 DIAL TONE flexible button (FLASH 40, Page B, Button #3). The following
message displays:
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
[0] = Disabled
[1] = Enabled
3. Press the HOLD button to save the entry. A confirmation tone sounds and the display
updates.
DEFAULT … Dial Tone option is disabled.
T-1 RINGBACK 0-1
ENABLE
T-1 DIAL TONE 0-1
DISABLED
To Next Page
Loading...
