2-52 Call Transfer
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
To make a Trunk-To-Trunk Transfer
1. Press the FLASH button. A dial tone will sound.
2. Dial [9].
-or-
Dial a CO line/group access code.
3. Dial the desired outside line destination number.
4. Hang up to complete the transfer.
Ringback on Transfer
Description
The Ringback on Transfer feature provides on a system-wide basis Music On Hold or ringback
tone to the CO caller when CO calls are transferred. Callers hear music if a music source is
connected to the system.
Programming Steps
1. Press the RINGBACK ON TRANSFER flexible button (FLASH 06, Button #11). The
following message displays:
2. Enter a 0 or 1 on the dial pad to enable/disable the use of this feature.
[0] = Disabled (Music, if music source is connected to system, otherwise silence)
[1] = Enabled (Ringback Tone)
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … Ringback on Transfer is disabled.
E911 feature enabled precludes dial 9 access.
RINGBACK ON XFER 0-1
DISABLED
To Next Page
Loading...
