Vodavi Starplus STSe - CO Line - Queue; Line Queuing

CO Line - Queue 2-91
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
CO Line - Queue
Description
When all outside lines in a group are busy, stations can be placed in queue awaiting a line in
the same group to become available. If a station doesn’t answer the queue signal within
15 seconds, that station is dropped from the queue. A station can queue only one line at a
time.
Line Queuing
Description
Stations can be allowed or denied the ability to manually queue for a busy group of CO lines.
Even when disabled, stations have automatic LCR queuing privileges.
Use Flash 50 programming when you want to modify a range of stations’ attributes using
fixed station numbers.
Use Flash 51 programming to modify a single station’s attributes using a flexible station
number.
Programming Steps
1. Press FLASH and dial [50] or dial [51]. Flexible button #24 (New Range) is lit and one of
the following messages displays:
2. Enter the range of fixed station numbers (100-149) to be programmed. If only one station
is being programmed, enter that number twice, e.g., [100 100].
-or-
Enter a valid flexible number (100-8999) to be programmed.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 is lit. The display updates to reflect current programming for Page A:
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
STATION ATTRIBUTES
SELECT A STATION RANGE
ENTER STATION NUMBER
If HOLD is pressed without entering a station range, all stations are selected.
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
XXX - XXX PAGE A
ENTER BUTTON NUMBER
SXXX PAGE A
ENTER BUTTON NUMBER
XXX-XXX = fixed station range XXX = 3- or 4-digit flexible number