Repeat Redial 2-259
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Repeat Redial
Description
The Repeat Redial feature allows a digital key station to press a flexible button and redial a
busy or no-answer number after a specific interval. The user is signaled via a queue call back
indication.
The RPT REDIAL flexible button flashes at the call back rate of 120 ipm for 15 seconds. If the
station:
Doesn’t answer within the 15 seconds, the call back is canceled. The system retains the
last call the user made.
Is busy on an internal/external call when the Redial queue call back occurs, the call back
does not occur until the user goes on-hook.
The user must enter a Redial Timer value when invoking this feature. This value is from
006-999 seconds. A 2-minute interval is entered as 120.
Programming Steps
1. Press the RPT REDIAL flexible button (FLASH 02, Button #1). The following message
displays:
2. Enter a valid number that corresponds to 006-999 seconds.
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Repeat Redial Timer is set for 1 minute (60) and is variable from 006-999 seconds.
Operation
A keyset station user places a CO call and receives a Busy or No Answer:
1. Press the preprogrammed RPT REDIAL flexible button [643]. The LCD prompts the user for
a timer value.
2. Enter a valid number (000-999 seconds) for the Repeat Redial Timer. Entry of 000 will
cancel the Repeat Redial feature. Default value is 060 (one minute). A confirmation tone
sounds and the station user goes on-hook. The flexible button LED lights steady.
When the timer expires, the station is signaled via a CO line queue indication on the RPT
REDIAL flexible button. During the Queue Call Back, the LCD display indicates this is a
Redial Call Back. Once line queue is answered, the LCD indicates an outgoing CO line
display.
RPT REDIAL 006-999
060
ENTER RPT REDIAL TIMER:
XXX 000-999
To Next Page
Loading...
