External Day Ring 2-159
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
External Day Ring
Description
The system can be programmed so CO lines marked for UDA provides ringing out of the
external page ports when the system is in the Day Mode.
Programming Steps
1. Press the EXT DAY RING flexible button (FLASH 06, Button #5). The following message
displays:
2. Enter a 0 or 1 on the dial pad to enable/disable External Day Ring.
[0] = Disabled
[1] = Enabled
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … External Day Ring is disabled.
External Night Ring
Description
When outside lines are marked UNA, ringing activates a tone over external paging when an
incoming call occurs on those lines during night service.
Programming Steps
1. Press the EXT NIGHT RING flexible button (FLASH 05, Button #3).
2. Enter a valid number (0 or 1) that corresponds with the following entries:
[0] = Disabled
[1] = Enabled
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … External Night Ring is disabled.
EXTERNAL DAY RING 0-1
DISABLED
EXTERNAL NIGHT RING 0-1
DISABLED
To Next Page
Loading...
