Centrex/PBX 2-57
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Centrex/PBX
The following features provide Centrex compatibility so that the STSe system’s toll restriction
feature can correctly interpret Centrex digits.
CO / PBX Programming
Description
Each individual outside line connected to the system may be programmed as a CO or PBX
line. Use the PBX mark when identifying Centrex lines.
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
XXX-XXX = CO Line Range
4. Press the CO/PBX flexible button (Button #2).
5. Enter a 0 or 1 which corresponds with the following entries:
[0] = PBX
[1] = CO
6. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … All lines are assigned as CO lines.
CO LINE ATTRIBUTES
SELECT A CO LINE RANGE
If HOLD is pressed without entering a CO line range, all CO lines are selected.
XXX - XXX PAGE A
ENTER BUTTON NUMBER
PBX / CO 0-1
CO
To Next Page
Loading...
