2-314 Tenant Group s
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 is lit. The display updates to reflect current programming for Page A:
4. Press button #22. The display updates to reflect current programming for Page D.
5. Press Button #1 and the following displays:
6. Enter a valid number 0-9 to assign the station(s) to a Tenant Group 0-9 respectively.
7. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … All stations are assigned to Tenant Group 0.
CO Line Assignments for Tenant Groups
Description
When a particular Tenant Group member dials 9 to access a CO line, that member has access
to CO lines based on what is programmed in this feature.
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
XXX - XXX PAGE A
ENTER BUTTON NUMBER
SXXX PAGE A
ENTER BUTTON NUMBER
XXX-XXX = fixed station range XXX = 3- or 4-digit flexible number
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
XXX - XXX PAGE D
ENTER BUTTON NUMBER
SXXX PAGE D
ENTER BUTTON NUMBER
XXX-XXX = fixed station range XXX = 3- or 4-digit flexible number
TENANT GROUP 0-9
0
CO LINE ATTRIBUTES
SELECT A CO LINE RANGE
If HOLD is pressed without entering a CO range, all CO lines are selected.
To Next Page
Loading...
