2-352 Voice Mail Outpulsing Table
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Programming Steps
1. Press FLASH and dial [66]. The following message displays:
Y = Table Index (0–7)
X = Entered Digits (0–9, #,
, Pauses)
2. The TABLE 00 flexible button (Button #1) led is lit. To change tables, press the appropriate
flexible button (Buttons 2–8) and perform the following procedures.
3. Dial one of the following, when required:
[0] = If a prefix is required
[1] = If a suffix is required
[#] = If entry is to be deleted
4. Enter up to 12 digits, including [
] and [#], TRANS button = pause.
5. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
To clear entries in a table:
Press the pound key once [#], followed by HOLD.
Entries are not required in the Outpulsing Table. However, a table must be
referenced when setting up the Voice Mail groups for the system to send digits
to the voice mail.
VOICE PRE XXXXXXXXXXXXE
MAIL Y SUF XXXXXXXXXXXXE
To Next Page
Loading...
