ISDN Programming - Page B 2-211
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
ISDN Line Parameters and Timers
Programming Steps
1. Press the ISDN flexible button (FLASH 85, Button #16). The following message displays:
2. To print the ISDN Parameters, press the HOLD button. The following message displays:
When the system has finished sending the requested information to the printer,
confirmation tone sounds.
ISDN ATTRIBUTES
---------------
SLOT 7
------
BRI CO TYPE - NI1
PRI CO TYPE - NI2
FRAMING - ESF
NT/TE MODE - TE
POWER - DISABLED
DIRECTORY NUMBER -
MAX OUT I-FRAMES K- 1
LEADING 1 - ENABLED
LEADING 011 - ENABLED
7/8 DIGIT NUMBER PLAN - ITU
10 DIGIT NUMBER PLAN - ITU
11 DIGIT NUMBER PLAN - ITU
CALLING_NUMBER - ENABLED
LOOPBACK - NORMAL
MAX # RETRANSMSN N200- 3
MAX OCTETS N201- 260
MAX TEI RQST N202- 3
MAX # XID RETRANSMSN N204- 3
T200 - 1
MIN TIEID CHK MSG T201- 1
MIN TIEID RQST MSG T202- 2
MSG EXCHANGE TIMER T203- 15
MIN # XID RETRANSMSN T204- 3
INTER-DIGIT T/O T302- 25
SETUP TIMER T303- 10
DISCONNECT TIMER T305- 4
RELEASE REQUEST T308- 4
LINK DISCONNECT T309- 30
CALL PROCEEDING T310- 60
CONNECT REQUEST T313- 4
RESTART REQ TIMER T316- 120
Figure 2-17: ISDN Attributes Printout
PRINT ISDN
PRESS HOLD
PRINTING ISDN
To Next Page
Loading...
